GB UA KN3C62A/EU S Operating Instructions

The openings used for the ventilation and dispersion of heat must never be covered. Do not use steam jets to clean the appliance. Always remember to rinse the appliance well with clean water and dry it thoroughly: Do not use extension cords or multiple sockets.! The cooking zone with radiant heating elements.


Account Options

Avoid using the same cookware that is used on gas burners: Never leave a cooking zone switched on without a pan on top of it, as doing so may cause the zone to become damaged.

Continuing the cooking of large quantities of food, minestrone For roasting average For roasting above average 6 For browning and reaching a boil in a short time. This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. General safety These instructions are only valid for the countries whose symbols appear in the manual and on the serial number plate located on the appliance.

The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. The appliance must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain and storms.

Do not touch the appliance with bare feet or with wet or damp hands and feet. The appliance must be used by adults only for the preparation of food, in accordance with the instructions outlined in this booklet. Any other use of the appliance e.

The manufacturer may not be held liable for any damage resulting from improper, incorrect and unreasonable use of the appliance. The instruction booklet accompanies a class insulated or class - subclass recessed between cupboards appliance.

Do not touch the heating elements or certain parts of the oven door when the appliance is in use; these parts become extremely hot. Keep children well away from the appliance. Make sure that the power supply cables of other electrical appliances do not come into contact with the hot parts of the oven.

The openings used for the ventilation and dispersion of heat must never be covered. Do not use unstable or misshapen pans on the cooking zones; this will help to avoid accidental spills. Make sure pan handles are turned towards the centre of the hob in order to avoid accidental burns.

Always use oven gloves when placing cookware in the oven or when removing it. Do not use flammable liquids alcohol, petrol, etc Do not place flammable material in the lower storage compartment or in the oven itself. If the appliance is switched on accidentally, it could catch fire.

Always make sure the knobs are in the position when the appliance is not in use. When unplugging the appliance, always pull the plug from the mains socket; do not pull on the cable. Never perform any cleaning or maintenance work without having disconnected the appliance from the electricity mains.

If the appliance breaks down, under no circumstances should you attempt to perform the repairs yourself. Repairs carried out by inexperienced persons may cause injury or further malfunctioning of the appliance. Do not rest heavy objects on the open oven door. The internal surfaces of the compartment where present may become hot. The glass ceramic hob is resistant to mechanical shocks, but it may crack or even break if hit with a sharp object such as a tool.

If this happens, disconnect the appliance from the electricity mains immediately and contact a Service Centre. If the surface of the hob is cracked, switch off the appliance to prevent electric shocks from occurring. Remember that the cooking zones remain relatively hot for at least thirty minutes after they have been switched off.

Keep any object which could melt away from the hob, for example plastic and aluminium objects, or products with a high sugar content. Be especially careful when using plastic film and aluminium foil or packaging: Do not place metal objects knives, spoons, pan lids, etc. The appliance should not be operated by people including children with reduced physical, sensory or mental capacities, by inexperienced individuals or by anyone who is not familiar with the product. These individuals should, at the very least, be supervised by someone who assumes responsibility for their safety or receive preliminary instructions relating to the operation of the appliance.

Do not let children play with the appliance. Disposal When disposing of packaging material: Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection.

For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. Respecting and conserving the environment You can help to reduce the peak load of the electricity supply network companies by using the oven in the hours between late afternoon and the early hours of the morning.

Never use steam cleaners or pressure cleaners on the appliance. Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack. The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge which has been soaked in lukewarm water and neutral soap.

Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances. The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth.

Do not use abrasive products. The accessories can be washed like everyday crockery, and are even dishwasher safe. Dirt and grease should be removed from the control panel using a non-abrasive sponge or a soft cloth. Stainless steel can be marked by hard water that has been left on the surface for a long time, or by aggressive detergents that contain phosphorus.

We recommend that the steel surfaces are rinsed well then dried thoroughly. Inspecting the oven seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Aftersales Service Centre. We recommend that the oven is not used until the seals have been replaced. Replacing the oven light bulb.

After disconnecting the oven from the electricity mains, remove the glass lid covering the lamp socket see figure.. Unscrew the light bulb and replace it with a similar one: Replace the lid and reconnect the oven to the electricity supply.

Cleaning the glass ceramic hob! Do not use abrasive or corrosive detergents for example, products in spray cans for cleaning barbecues and ovens , stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: It is usually sufficient simply to wash the hob using a damp sponge and dry it with absorbent kitchen roll. If the hob is particularly dirty, rub it with a special glass ceramic cleaning product, then rinse well and dry thoroughly.

The following warnings are provided for safety reasons and must be read carefully. It is extremely dangerous to leave the appliance exposed to rain and storms. Any other use of the appliance e. The manufacturer may not be held liable for any damage resulting from improper, incorrect and unreasonable use of the appliance. Keep children well away from the appliance. Make sure pan handles are turned towards the centre of the hob in order to avoid accidental burns.

If the appliance is switched on accidentally, it could catch fire. Do not rest heavy objects on the open oven door. The internal surfaces of the compartment where present may become hot. The glass ceramic hob is resistant to mechanical shocks, but it may crack or even break if hit with a sharp object such as a tool. If this happens, disconnect the appliance from the electricity mains immediately and contact a Service Centre.

If the surface of the hob is cracked, switch off the appliance to prevent electric shocks from occurring. Remember that the cooking zones remain relatively hot for at least thirty minutes after they have been switched off.

Keep any object which could melt away from the hob, for example plastic and aluminium objects, or products with a high sugar content. Be especially careful when using plastic film and aluminium foil or packaging: Do not place metal objects knives, spoons, pan lids, etc. The appliance should not be operated by people including children with reduced physical, sensory or mental capacities, by inexperienced individuals or by anyone who is not familiar with the product.

These individuals should, at the very least, be supervised by someone who assumes responsibility for their safety or receive preliminary instructions relating to the operation of the appliance. Do not let children play with the appliance. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health.

The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer.

Care and maintenance Switching the appliance off Cleaning the glass ceramic hob Disconnect your appliance from the electricity supply before carrying out any work on it.

Do not use abrasive or corrosive detergents for example, products in spray cans for cleaning barbecues and ovens , stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: Never use steam cleaners or pressure cleaners on the appliance. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack.

Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products. We recommend that the steel surfaces are rinsed well then dried thoroughly. Inspecting the oven seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Aftersales Service Centre.

We recommend that the oven is not used until the seals have been replaced. Replacing the oven light bulb 1. After disconnecting the oven from the electricity mains, remove the glass lid covering the lamp socket see figure.

Unscrew the light bulb and replace it with a similar one: Replace the lid and reconnect the oven to the electricity supply. Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can obtain excellent results by using a rustproof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water.

This maintenance should be carried out while the appliance is warm not hot or cold. Never use the services of an unauthorised technician.

Please have the following information to hand: The latter two pieces of information can be found on the data plate located on the appliance. Es importante conservar este manual para poder consultarlo en todo momento.

Lea atentamente las instrucciones: Si los armarios son de material inflamable, dicha distancia debe ser de mm. El cable no debe sufrir pliegues ni compresiones.

La empresa declina toda responsabilidad en los casos en que no hayan sido respetadas estas normas. Se enciende el elemento calentador inferior.

Se enciende el elemento calentador superior. Se enciende el elemento calentador superior central. The grill is also highly recommended for dishes that require a high temperature on the surface: Always leave the oven door ajar during cooking, except when using the turnspit. The top central heating element and the fan come on.

This combination of features increases the effectiveness of the unidirectional thermal radiation of the heating elements through forced circulation of the air throughout the oven. This helps prevent food from burning on the surface, allowing the heat to penetrate right into the food. Excellent results are achieved with kebabs made with meats and vegetables, sausages, ribs, lamb chops, chicken in a spicy sauce, quail, pork chops, etc. This mode is also ideal for cooking fish steaks, like swordfish, tuna, grouper, stuffed cuttlefish etc.

Lower oven compartment There is a compartment underneath the oven that may be used to storeoven accessories or deep dishes. To open the door pull it downwards see figure. Do not place flammable materials in the lower oven compartment. We also recommend that: Positions 2 and 4 are used and that food that requires more heat is placed on the rack in position 2.

When cooking foods that require different cooking times and temperatures, set a temperature that is halfway between the two recommended temperatures see Oven cooking advice table and place the more delicate food on the rack in position 4. Remove the food that requires a shorter cooking time first. Generally speaking, cooking on the rack in position 4 takes longer: Place the dripping pan on the bottom and the rack on top.

Oven cooking advice table Selector knob Food to be cooked setting Baking Tarts Fruit cakes Plum cake Sponge cake Stuffed pancakes on 2 racks Small cakes on 2 racks Cheese puffs on 2 racks Cream puffs on 3 racks Biscuits on 3 racks Meringues on 3 racks GB Weight in kg Cooking rack position from bottom Preheating time minutes Thermostat knob setting Cooking time minutes 0.

When cooking using the grill or fan assisted grill, the dripping pan must always be placed on the 1st oven rack from the bottom. The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly.

Switching the cooking zones on and off To switch on a cooking zone, turn the corresponding knob in a clockwise direction. Cooking zones The hob is equipped with electric radiant heating elements. When they are in use A A the following items on the hob become red.

The residual heat B indicator light: Cooking zones with radiant heating elements They have similar properties to gas burners: Turn the corresponding knob in a clockwise direction, to a position between 1 and 6. This appliance has been designed and manufactured in compliance with international safety standards.

The following warnings are provided for safety reasons and must be read carefully. It is, however, wise to remember that blades or cooking utensils may ruin the surface of the hob. If this happens, remove the plug of the cooker from the electricity socket and contact an authorised Technical Assistance Centre in order to request original spare parts.

Failure to comply with the above may compromise the safety of the appliance. It is extremely dangerous to leave the appliance exposed to rain and storms. Any other use of the appliance e. If the appliance is switched on accidentally, it could catch fire. Repairs carried out by inexperienced persons may cause injury or further malfunctioning of the appliance. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health.

The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. Exhausted appliances may be collected by the public waste collection service, taken to suitable collection areas in the area or, if permitted by current national legislation, they may be returned to the dealers as part of an exchange deal for a new equivalent product. All major manufacturers of household appliances participate in the creation and organisation of systems for the collection and disposal of old and disused appliances.

Do not use steam jets to clean the appliance. Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.

Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack. Inspecting the oven seals Check the door seals around the oven regularly.

If the seals are damaged, please contact your nearest Aftersales Service Centre. We recommend that the oven is not used until the seals have been replaced. Replacing the oven light bulb 1.

After disconnecting the oven from the electricity mains, remove the glass lid covering the lamp socket see figure. Remove the light bulb and replace it with a similar one: Replace the lid and reconnect the oven to the electricity supply. Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can obtain excellent results by using a rustproof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water.

This maintenance should be carried out while the appliance is warm not hot or cold. We recommend that the steel surfaces are rinsed well then dried thoroughly. Assistance Cleaning the glass ceramic hob!


Leave a Reply